Cerberus Controller Holder – Black Three-Headed Hellhound Stand, Gothic Gaming Desk Decor, Gamer Gift

Give your controller a guardian. This original Cerberus controller holder features three snarling heads, sculpted chains, and a skull-covered base—all printed in black for a bold fantasy centerpiece.

The cradle sits behind Cerberus, keeping your controller on display while the creature takes center stage. It also makes a striking display piece when your controller is in use.

• Original Cerberus design
• All-black finish
• Detailed three-headed hellhound with chains and skulls
• 3D printed in PLA plastic
• Includes one controller holder

Controller Placement

Place your controller in the orientation shown in the photos, with the buttons facing forward above the Cerberus heads. The photos show an Xbox controller; fit may vary with other controller shapes, sizes, or protective covers.

Controller shown in photos is NOT included.

Approximate Dimensions

Width: 90.41 mm / 3.56 inches
Depth: 110.58 mm / 4.35 inches
Height: 114.78 mm / 4.52 inches

3D-Printed Finish

Each piece is 3D printed and may show visible layer lines, minor scratches or marks, occasional rough or jagged edges, and small surface variations. Support removal may leave small marks or slightly rough areas. These characteristics are part of the printing process, so the finish may differ from the perfectly smooth surface of an injection-molded, mass-produced item.

Care

Keep away from high heat and direct sunlight. Clean gently with a soft, dry cloth and handle detailed areas with care.

Designed and 3D printed by MadeByJohnnyG.