Treecko Controller Holder – 3D Printed Pokémon Gaming Controller Stand

Bring some Pokémon personality to your gaming setup with this custom 3D-printed Treecko Controller Holder!

Treecko stands approximately 5.9 inches tall with his signature crossed-arm pose and oversized green tail, while an integrated holder behind his body securely supports a gaming controller without taking away from the character’s appearance.

This isn’t just a display figure—the holder has been physically printed and tested with real controllers.

Controller Compatibility

* ✅ Xbox controller — physically tested
* ✅ Nintendo Switch 2 controller — physically tested
* ⚠️ PlayStation 5 DualSense — not currently tested

The controller rests behind Treecko while Treecko remains fully visible from the front, making it both a functional controller stand and a display piece.

Approximate Dimensions
3.22” W × 4.97” D × 5.91” H
(81.71 × 126.29 × 150.02 mm)

Colors
Light green body, darker green tail, red chest/throat, yellow eyes with black and white detailing.

Please Note
This item is individually 3D printed rather than mass-produced. Visible layer lines, rough or jagged areas, minor support marks, small surface imperfections, and slight variations may be present. These are normal characteristics of FDM 3D printing. Please review the listing photos closely, as they show the appearance and finish of the physical printed product.

Controller shown in photos is for demonstration purposes only and is not included.

Designed and 3D printed by MadeByJohnnyG.